STUDY OF MAINTENANCE OF UPS EQUIPMENT (UNINTERUPTABLE POWER SUPPLY) WITH FAULT TREE ANALYSIS (FTA) METHOD TO PRODUCE TIMELY POWER SUPPLY AVAILABILITY AT SOEKARNO-HATTA AIRPORT
DOI:
https://doi.org/10.22441/ihasj.2021.v4i1.03Abstract
Abstract - UPS (Uninteruptable Power Supply) is equipment that supports the availability of a continuous supply of electricity that will work when the main electricity supply from PLN is off and the secondary power supply (Genset) is not ready to take over the electricity supply. The purpose of this study is to determine which equipment components are the cause of potential UPS equipment damage and provide advice on appropriate maintenance actions for the selected system using the Fault Tree Analysis (FTA) method. The study population was 7 units of UPS Benning with a capacity of 80 kVA located in different places at Soekarno-Hatta Airport. The results showed that the frequent damage was due to dead air conditioning which caused the temperature of the battery room to be high.
Keywords: Airport, Uninteruptible Power Supply (UPS), Fault Tree Analysis (FTA), proper maintenance
Downloads
References
Adinda Febby Mustika, M. Hamzah Hasyim, Saifoe El Unas. (2014). Analysis of Project Delays Using Fault Tree Analysis (FTA) (Case Study on the Construction Project of Phase II Industrial Engineering Study Program Building, Brawijaya University Malang). Essay. Brawijaya University. Poor.
Angga Permana Agustian. (2017). Analysis of the Delay Factors in the Pancoran Riverside Apartment Development Project Using the Fault Tree Analysis (FTA) Method.
Assauri, Sofyan. (2008). "Production and Operations Management". Jakarta: University of Indonesia.
Bhangu, N. Singh. (2015). Application of Fault Tree Analysis for Evaluating Reliability and Risk Assessment of a Thermal Power Plant.
Bimo Satriyo, Diana Puspitasari, ST. MT. (2015). Quality Control Analysis Using Fault Tree Analysis Method To Minimize Defects In Crank Bed In Pt Painting Line. Sarandi Karya Nugraha.
Chen-Yang Cheng et al. (2013). Application Of Fault Tree Analysis To Assess Inventory Risk A Practical Case From Aerospace Manufacturing.
Danang Priyo Nugroho. (2018). Proposed Maintenance on Line Drawing to Increase Reliability Value Using the FTA & FMEA Method at PT SCMC.
Fauziah, Naily. (2009). "Fishbone Analysis Application To Improve The Quality Of Production At PT. Rumpun Sari Kemuning, Karanganyar Regency ". Essay. Faculty of Agriculture. Sebelas Maret University. Surakarta.
Ferdiana, Tara and Priadythama, Ilham. (2015). Defect Analysis Using Fault Tree Analysis (FTA) Method Based on Ground Finding Sheet (GFS) Data of PT. GMF Aeroasia.
García Márquez et al. . (2017). Optimal Dynamic Analysis of Electrical / Electronic Components in Wind Turbines.
Heizer, Jay and Render, Barry. (2011). Second Book Operations Management. Jakarta: Four Salemba.
ICAO. (2016). Annex 14 Volume I 7th Edition of 2016 Chapter 8 concerning Electrical Systems. International Standards and Recommended Practices. Canada: ICAO
Julio Irfansyah and Lukmanul Hakim. (2018). Operational Risk Analysis with the Fault Tree Analysis Method and Failure Mode And Effect Analysis in the Trial of the Fulfillment Ftth Tripleplay System Process (Indihome).
Kurniawan, Fajar. (2013). Industrial Maintenance Management: Techniques and Applications for the Implementation of Total Productive Maintenance (TPM), Preventive Maintenance and Reability Centered Maintenance (RCM). Yogyakarta: Graha Science.
Lukowicz, Miroslaw et al. (2011). Selection of minimal tripping times for distance protection using fault trees with time dependencies.
Nasimi, Elnara. (2016). Application of Safety Instrumented System (SIS) approach in older nuclear power plants.
Nopita Sari Br Ginting. (2018). Analysis of the Effectiveness of Work Accident Risk Control on Construction Project Workers.
Nugraheni Djamal, Rifki Azizi. (2014). Identification and Improvement Plans for the Causes of Production Delay Melting Process with the Concept of Fault Tree Analysis (FTA) at PT. XYZ.
Nusraningrum, Dewi et.all. (2016). Application of Security Management Systems in Indonesian Aviation Navigation Service Organizing Institutions. Journal of Transportation & Logistics Management (JMTranslog) - Vol. 03 No.2, July 2016.
Nusraningrum, Dewi and Waluyaningsih, N. (2013). “Performance Analysis: The Case Directorate General of Civil Aviation Using Balanced Scorecard. World Journal of Social Sciences.
Indonesian government. (2009). Law of the Republic of Indonesia Number 1 of 2009 concerning Aviation item 31. State Gazette of the Republic of Indonesia of 2009. Jakarta: State Secretariat
Indonesian government. (2015). Regulation of the director general of air transportation number: kp 608 of 2015 concerning Operational Technical Guidelines for Civil Aviation Safety Regulations Section 139-27, Maintenance Procedure for Visual Landing Aids. Jakarta: Ministry of Transportation, Directorate General of Civil Aviation
Sahuri. (2016). "Analysis of the Implementation of the Maintenance Quality Function Model Deployment (MQFD) To Improve The Quality Of Maintenance At The DAOP 1 Jakarta Upper Flow Power Unit PT. Indonesian Railways ". Thesis. Master of Management Program. Mercubuana University. Jakarta.
Septian Braja P.P. (2019). Analysis of the Causes of Failure in the Fluid Separation Unit with the Reliability Centered Maintenance (Rcm) and Fault Tree Analysis (FTA) Methods.
Sember, Robert. (2010). UPS Battery Maintenance 101.
Shailee G. Acharya, Dr. J.A.Vadher. (2016). Design Quality Cost System Through Fault Tree Analysis (FTA) For Fnb Cast Iron Foundry Industry.
Smith, Anthony and Glenn R. Hinchcliffe. 2004. RCM - Gateaway to World Class Maintenance. London: Elsevier Inc
Sutawidjaya, Ahmad, H. Lenny Ch Nawangsari. Suharno. (2017). "A Framework for Strategic Distribution on Green Supply Chain Management". National Seminar on Innovation and Technology Application in Industry. ISSN 2085-4218.
Yang, Jie et al. (2017). Methodology to evaluate the reliability of performance of second-order automatic control systems.
Downloads
Published
How to Cite
Issue
Section
License
The copyright to this article is transferred to Universitas Mercu Buana (UMB) if and when the article is accepted for publication. The undersigned hereby transfers any and all rights in and to the paper including without limitation all copyrights to UMB. The undersigned hereby represents and warrants that the paper is original and that he/she is the author of the paper, except for material that is clearly identified as to its original source, with permission notices from the copyright owners where required. The undersigned represents that he/she has the power and authority to make and execute this assignment.
We declare that:
1. This paper has not been published in the same form elsewhere.
2. It will not be submitted anywhere else for publication prior to acceptance/rejection by this Journal.
3. A copyright permission is obtained for materials published elsewhere and which require this permission for reproduction.
Furthermore, I/We hereby transfer the unlimited rights of publication of the above mentioned paper in whole to UMB. The copyright transfer covers the exclusive right to reproduce and distribute the article, including reprints, translations, photographic reproductions, microform, electronic form (offline, online) or any other reproductions of similar nature.
The corresponding author signs for and accepts responsibility for releasing this material on behalf of any and all co-authors. This agreement is to be signed by at least one of the authors who have obtained the assent of the co-author(s) where applicable. After submission of this agreement signed by the corresponding author, changes of authorship or in the order of the authors listed will not be accepted.
Retained Rights/Terms and Conditions
1. Authors retain all proprietary rights in any process, procedure, or article of manufacture described in the Work.
2. Authors may reproduce or authorize others to reproduce the Work or derivative works for the authors personal use or for company use, provided that the source and the UMB copyright notice are indicated, the copies are not used in any way that implies UMB endorsement of a product or service of any employer, and the copies themselves are not offered for sale.
3. Although authors are permitted to re-use all or portions of the Work in other works, this does not include granting third-party requests for reprinting, republishing, or other types of re-use.
