Utilization of Siwalan Waste (Borassus flabellifer L.) as a Prototype of Active Carbon-Based Batteries Using Brunauer Emmett Teller (BET) and Analysis of Variance (ANOVA) Method

Isna Nugraha; Husna Zaka Anshori; Tivani Nava Arier; Izra Noor Aliya; Dwi Mulyati Ningrum; Achmad Gufron

doi:10.22441/ijiem.v5i3.23892

Utilization of Siwalan Waste (Borassus flabellifer L.) as a Prototype of Active Carbon-Based Batteries Using Brunauer Emmett Teller (BET) and Analysis of Variance (ANOVA) Method

Isna Nugraha, Husna Zaka Anshori, Tivani Nava Arier, Izra Noor Aliya, Dwi Mulyati Ningrum, Achmad Gufron

Abstract

Currently, electricity use in Indonesia has soared and continues to increase every year. New renewable energy will be the main alternative for the country as a source of electricity. Alternative energy sources can come from biomass such as Siwalan shell waste. This waste has a composition of 18.52% hemicellulose, 11.90% cellulose, 0.23% lignin, 0.1% nitrogen, 13.80% water, 4.46% ash, 44.58% carbon and 6.41% volatile matter. % which is the chemical component of the basic ingredient for making activated carbon. Thus, the aim of this research is to determine the capacitance of a battery prototype from activated carbon from Siwalan shell waste. The method used is a quantitative method by taking data from the results of the Brunauer Emmett Teller test and the Cyclic Voltammetry test. Carbon is activated using KOH with varying concentrations of 1 M; 1.5 M; 2M; 2.5 M. The results of the surface area of activated carbon in the BET test were 13,636 m2/g; 20,941 m2/g; 28,191 m2/g; and 29,871 m2/g and in manual calculations using the BET method it was obtained 13,647 m2/g; 20,950 m2/g; 28,197 m2/g; and 29,875 m2/g. From testing and manual calculations, Siwalan shell carbon at a KOH concentration of 2.5 M has the largest surface area and has the potential to be the best active carbon material for making battery prototypes.

Keywords

Siwalan; Prototype; Batteries, BET, Analysis of variance

Full Text:

PDF

References

Aperti, A. (2018). Potential Study of Utilizing Siwalan Palm Fiber Waste (Borassus Flabellifer L) as a Raw Material for Local Crafts (Thread) in Gresik. Teknologia Journal, 1(1), 79-88 ISSN 2654-5683. https://aperti.e-journal.id/teknologia/articl e/view/10

Electricity Statistics, Directorate General of Electricity, Ministry of Energy and Mineral Resources, Year 2021.

Elgishi, N., Rountree, K. J., McCarthy, B. D., & Rountree, E. S. (2018). A Practical Beginner’s Guide to Cyclic Voltammetry. Journal Chem. Educ. 95(2), 197-206. https://doi.org/10.1021/acs.jchemed.7b00361

Fitri, I.I. (2022). The influence of the calcination temperature of graphite-titanium dioxide (TiO2) on the performance of dye-sensitized solar cells (DSSC) based on dye extracted from Dracaena angustifolia leaves.Journal of Innovation Research and Knowledge, 2(4), 1971-1982. https://doi.org/10.53625/jirk.v2i4.3473

Handayani, R. T., & Suryaningsih, S. (2019). The Influence of Carbonization Temperature and Airflow Variation on the Combustion Rate of Mixed Briquettes. Wahana Fisika, 4(2), 98-103. https://doi.org/10.17509/wafi.v4i2.15582

Hutapea, E. M., Iwantono, Farma, R., Saktioto, dan Awitdrus. (2017). Production and Characterization of Activated Carbon from Betung Bamboo (Dendrocalamus Asper) using KOH Activation Assisted by Microwave Irradiation. Indonesian Journal of Physics Communication, 14(2), 1061-1066. https://www.researchgate.net/ profile/Iwantono-Iwantono-2/publication/ 324137185

Huda, M. M. (2022). Heavy Metal Lead (Pb) Adsorption in Artificial Wastewater using Water Hyacinth Derived Activated Carbon with ZnCl2 Activator Addition. Thesis. UPN Veteran East Java.

Hwang, N., Barron, A.R. (2011). BET surface area analysis of nanoparticles. Connex. Proj., 8 (2), 1–11. http://cnx.org/content/ m38278/1.1/

Ihsan, F. (2022). Utilization of Siwalan Palm (Borassus Flabellifer L) Husk Waste as Activated Carbon with ZnCl2 and Na2CO3 Activators for Used Cooking Oil Purification. Dissertation. Maulana Malik Ibrahim State Islamic University.

Khairiah, J. H. (2019). The Influence of Electrical Conductivity of Durian Peel Graphite Carbon Black Slurry (Durio Zibethinus) on Surface Area and Pore Radius.In Proceedings of the National Research Results Seminar, 2(2), 1109-1112). E-ISSN: 2621-5284. https://e-prosiding.umnaw.ac.id/index.php/penelitian/article/view/325

Kusumaningtyas, M. P. (2017). Analysis of the Nanostructure of Lombok Pumice Using the BET (Brunauer-Emmett-Teller) Method. Dissertation. Sepuluh Nopember Institute of Technology.

Marpaung, J. L., Lumintang, R. C. A., & Sutrisno, A. (2017). Application of ANOVA Method for the Analysis of Mechanical Properties of Coconut Fiber Composites. Journal of Mechanical Engineering Shaft UNSRAT, 6(2), 151-162. Retrieved from. https://ejournal. unsrat.ac.id/v3/index.php/poros/article/view/17767/17291

Nasution, M. (2021). The Characteristics of Batteries for Specific Electrical Energy Storage.Journal of Electrical Technology, 6(1), 35-40. ISSN : 2598 – 1099. https://doi.org/10.30743/jet.v6i1.3797

Pahlevi, M.A., Junaidi, R. and Hc, F. (2020). Prototype of Activated Carbon-Based Batteries from Betung Bamboo (Review of the Influence of Activated Carbon and Electrolyte in Enhancing Battery Performance). Kinetika, 11(1), 55-60. https://jurnal.polsri.ac.id/index.php/kimia/article/view/3111

Pasaribu, F. I., & Reza, M. (2021). Design and Construction of an Arduino-Based Charging Station Using a 50 WP Solar Cell. RELE (Electrical and Energy Engineering). Journal of Electrical Engineering, 3(2), 46-55. https:// doi.org/10.30596/rele.v3i2.6477

Putri, A. Z. (2019). Analisis teoritik nanopartikel Zirkonium Dioksida (ZrO2) (Theoretical analysis of Zirconium Dioxide (ZrO2) nanoparticles). Pillar Of Physics, 12(1), 70-76. http://dx.doi.org/ 10.24036/6314171074

Radhiana, R., Yana, S., Muzailin, M., Zainuddin, Z., Susanti, S., Kasmaniar, K. And Hanum, F. (2023). Sustainability Strategies for Long-Term Development of Renewable Energy in Indonesia: A Case of Renewable Biomass Energy in the Agriculture, Plantation, and Forestry Sectors of Indonesia. Serambi Engineering Journal, 8(1), 9127-9136. https://jse.serambimekkah.id/index.php/jse/article/view/417

Rizki, A. D. (202)1. Analysis of the Effect of Acid-Activated Clay Mass as an Adsorbent in Adsorbing Pb2+ Metal Ions. Doctoral dissertation. Kalimantan Institute of Technology, Kalimantan.

Saputra, N.A., Nawawi, D.S., Maddu, A., Pari, G. and Syafii, W. (2022). Biomass as a Supercapacitor Electrode Material. Forest Research Journal, 40(3), 189-202. https://doi.org/10.32528/nms.v2i3.274

Sinha, P., Datar, A., Jeong, C., Deng, X., Chung, Y. G., & Lin, L. C. (2019). Surface area determination of porous materials using the Brunauer–Emmett–Teller (BET) method: limitations and improvements. The Journal of Physical Chemistry C., 123(33), 20195-20209. https://doi.org/ 10.1021/acs.jpcc.9b02116

Tumimomor, F. R., Bahri. A, Palilingan, S. C. (2018). Utilization of Activated Carbon from Coconut Coir as Supercapacitor Electrode.Fullerene Journal Of Chemistry, 3(1), 13-18. https://doi.org/ 10.37033/fjc.v3i1.29

Waluyo, H.M., Faryuni, I.D. and Muid, A. (2017). Analysis of the Influence of Pore Size on the Electrical Properties of Activated Carbon from Oil Palm Empty Fruit Bunches in Battery Prototype. FLUX Physics Journal, 14(1), 27-33. http:// dx.doi.org/10.20527/flux.v14i1.3777

WasanaWasana, M. P. A. (2022). The Addition of Siwalan Palm Husk Charcoal (Borassus Flabellifer L.) to the Growing Medium Mixture for Strawberry Plants (Fragaria Sp.). Doctoral Dissertation. Muhammadiyah University of Malang.

Yana S, M. Nizar, Irhamni, and D. Mulyati. (2022). Biomass waste as a renewable energy in developing bio-based economie. Renewable Sustainable, Energy Rev, 160(1), 112268-112283. https://doi.org /10.1016/j.rser.2022.112268

DOI: http://dx.doi.org/10.22441/ijiem.v5i3.23892

Refbacks

There are currently no refbacks.

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

IJIEM - Indonesian Journal of Industrial Engineering & Management
Program Pascasarjana Magister Teknik Industri Universitas Mercu Buana
Kampus Menteng - Gedung Tedja Buana, Floor 4^th
Jl. Menteng Raya No. 29 Jakarta Pusat- Indonesia
Tlp.: +62 21 31935454 Fax: +62 21 31934474
http://publikasi.mercubuana.ac.id/index.php/ijiem

Email: [email protected]

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.