TIRE WASTE AS A POTENTIAL MATERIAL FOR CARBON ELECTRODE FABRICATION: A REVIEW

Penulis

  • Ahmad Ariri Mechanical Engineering Department, Universitas Mercu Buana
  • Sagir Alva Mechanical Engineering Department, Universitas Mercu Buana
  • Siti Aishah Hasbullah Department of Chemical Sciences, Faculty of Science and Technology, Universiti Kebangsaan Malaysia

DOI:

https://doi.org/10.22441/sinergi.2021.1.001

Kata Kunci:

Carbon, Electrode, Pyrolysis, Tire disposal, Tire Waste

Abstrak

Nowadays, tire waste is a big issue since the rapid growth of vehicle population worldwide. The disposal of tire waste should be done properly due to the environmental impact caused by stockpile the tire waste in landfill.  Many kinds of research had been conducted to dispose of tire waste efficiently for getting valuable material from tire waste by using pyrolysis technology; one of them is carbon. In this review paper, production and application of carbon from tire waste presented. In several studies, carbon derived from tire waste was used as an adsorbent, electrode in energy storage application, like batteries and fuel cell.

Unduhan

Data unduhan belum tersedia.

Diterbitkan

2020-11-05

Cara Mengutip

[1]
A. Ariri, S. Alva, dan S. A. Hasbullah, “TIRE WASTE AS A POTENTIAL MATERIAL FOR CARBON ELECTRODE FABRICATION: A REVIEW”, Sinergi, vol. 25, no. 1, hlm. 1–10, Nov 2020.

Terbitan

Bagian

Articles

Artikel paling banyak dibaca berdasarkan penulis yang sama

Artikel Serupa

<< < > >> 

Anda juga bisa Mulai pencarian similarity tingkat lanjut untuk artikel ini.