Synergistic effects of low-cost graphene and coal fly ash on the strength–porosity performance of cellular lightweight concrete

Authors

  • Yola Bertilsya Hendri Department of Chemical Engineering, Universitas Riau, Indonesia
  • Ahlun Nazar Department of Chemical Engineering, Universitas Riau, Indonesia
  • Geta Arianty Department of Chemical Engineering, Universitas Riau, Indonesia
  • Dhina Febryza Department of Chemical Engineering, Universitas Riau, Indonesia
  • Hussein A. Miran Department of Physics, College of Education for Pure Science, Ibn Al-Haitham, University of Baghdad, Iraq
  • Zainab N. Jaf Department of Physics, College of Education for Pure Science, Ibn Al-Haitham, University of Baghdad, Iraq
  • M. Mahbubur Rahman Deparment of Physics, Jahangirnagar University, Bangladesh
  • Hatem Taha Surface Analysis and Materials Engineering Research Group, School of Engineering & Information Technology, Murdoch University, Australia , Australia
  • Zhong Tao Jiang Surface Analysis and Materials Engineering Research Group, School of Engineering & Information Technology, Murdoch University, Australia
  • Amun Amri Department of Chemical Engineering, Universitas Riau, Indonesia

DOI:

https://doi.org/10.22441/sinergi.2026.3.025

Keywords:

Cellular Lightweight Concrete (CLC), Coal Fly Ash, Compressive Strength, Low-Cost Graphene, Porosity–Strength Trade-Off

Abstract

Cellular lightweight concrete (CLC) is attractive for envelope and infill applications due to its low density and low thermal and sound insulation. However, its high pore volume often reduces compressive strength and limits wider application. Graphene-based additives and fly ash have been widely studied in cementitious composites. However, their combined effect in low-density CLC remains insufficiently understood, particularly regarding the strength-porosity balance, cellular pore stability, and microstructural mechanism. This study investigated the synergistic effect of low-cost graphene produced by turbulence-assisted shear exfoliation (TASE) and coal fly ash on CLC with a target density of approximately 1.1 g·cm⁻³. TASE graphene was selected because its aqueous shear-exfoliation route offered lower processing complexity, better scalability, and stronger cost potential than many commercial or oxidized graphene derivatives, making it more suitable for large-volume cementitious applications. CLC mixtures containing 0–15 wt.% graphene and 0 or 5 wt.% fly ash were cast and cured for 14 and 28 days. Compressive strength, porosity, and microstructure (SEM/TEM) were evaluated. Among the investigated mixtures, the mixture containing 10 wt.% graphene and 5 wt.% fly ash produced the best strength–porosity performance, achieving the highest 28-day compressive strength of 1.86 ± 0.20 MPa and the lowest porosity of 23.70%. Compared with the graphene-free mixture at the same fly ash level, this composition increased strength by 64.60% and reduced porosity by 14.84%. SEM/TEM observations supported a dosage-dependent mechanism involving graphene-assisted nucleation, fly ash-assisted pozzolanic densification, pore-wall refinement, and reduced reinforcement efficiency at excessive graphene loading. These findings supported the practical design of graphene–fly ash modified CLC material systems.

Downloads

Download data is not yet available.

Downloads

Published

2026-10-06

How to Cite

[1]
Y. B. Hendri, “Synergistic effects of low-cost graphene and coal fly ash on the strength–porosity performance of cellular lightweight concrete”, Sinergi, vol. 30, no. 3, pp. 1023–1036, Oct. 2026.

Issue

Section

Articles

Similar Articles

> >> 

You may also start an advanced similarity search for this article.