Design and Analysis of a Vertical Axis Ocean Current Turbine Tunnel Using SolidWorks Computational Fluid Dynamics
Abstract
The development of renewable energy in the marine power generation sector presents a promising approach to producing electrical energy in a sustainable and environmentally friendly manner. Indonesia, with its vast oceanic territory, holds significant potential for harnessing marine energy. However, the relatively slow speed of ocean currents in the region, typically ranging from 0.1 m/s to 1.5 m/s, poses a challenge to the efficiency of marine power generation. To overcome this limitation, this research focuses on the design and analysis of a vertical-axis ocean current turbine tunnel aimed at increasing the speed of ocean currents, thereby enhancing the overall efficiency of energy production. The study combines a thorough literature review with experimental research methods, utilizing SolidWorks Computational Fluid Dynamics (CFD) software to simulate the tunnel's impact on ocean current velocity. The simulations reveal that the tunnel construction significantly boosts current speeds, increasing them from 1.0 m/s to 1.7 m/s, and from 1.5 m/s to 2.6 m/s. This increase in velocity directly translates to higher kinetic energy available for conversion into electrical power by the turbine. Moreover, the study shows that the tunnel construction contributes to a more uniform flow of ocean currents, as evidenced by the Reynolds numbers obtained—100.250 at a current speed of 1.0 m/s and 150.375 at 1.5 m/s. These values, being below 2000, indicate laminar flow conditions within the tunnel, which are beneficial for optimizing turbine performance by reducing turbulence and ensuring a stable energy output. The findings underscore the effectiveness of the tunnel design in improving the efficiency of vertical-axis ocean current turbines, making it a viable solution for enhancing renewable energy production in regions with low ocean current speeds.
Keywords
Full Text:
PDFReferences
W.M. Rumaherang, R. Ufie, W.M.E. Wattimena, and B.G. Tentua, “Karakteristik turbin propeller sumbu horisontal pembangkit listrik tenaga arus laut,” Archipel. Engineering., vol. 1, no. 1, pp. 90–95, 2018.
A. Kasharjanto, E. Erwandi, E. Marta, Z. Irawanto, D. Rahuna, and S.J.M. Cahyadi, “Study of the motion performance of marine current power plant turbine floaters due to ocean current forces under moored conditions,” Kapal: Jurnal Ilmu Pengetahuan dan Teknologi Kelautan, vol. 20, no. 3, pp. 343–349, 2023.
R.M. Lopulalan, “Desain blade turbin pembangkit listrik tenaga arus laut di Banyuwangi berbasis CFD,” Jurnal Teknik ITS, vol. 5, no. 2, pp. 424–430, 2016.
S.E. Yulianto,“ Analisa putaran dan torsi turbin arus laut akibat pengaruh variasi diameter dan jumlah blade,” Undergraduate thesis, Institut Technology Sepuluh Nopember, 2015.
H. Li, L. Yu, and Y. He, “Modified BEM methods for the marine current turbine performance analysis under non-uniform inflow condition,” Proc. 5th International Symposium on Marine Propulsors (SMP'17), 2017.
T. Blackmore, W.M.J. Batten, and A.S. Bahaj, “Influence of turbulence on the wake of a marine current turbine simulator,” Proceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences, vol. 470, no. 2170, 2014.
N. Ruhyat, “Comparison of the dryer air inlet position on the spray dryer with a double condenser to produce a rotating flow throughout the drying chamber: CFD analysis,” International Journal of Innovation in Mechanical Engineering & Advanced Materials, vol. 5, no. 1, 2023.
P. Mycek, B. Gaurier, G. Germain, G. Pinon, and E. Rivoalen, “Experimental study of the turbulence intensity effects on marine current tur-bines behaviour. Part II: Two interacting turbines,” Renewable. Energy, vol. 68, pp. 876–892, 2014, doi: 10.1016/j.renene.2013.12.048.
W. Hua-Ming, Q. Xiao-Kun, C. Lin, T. Lu-Qiong, and W. Qiao-Rui, “Numerical study on energy-converging efficiency of the ducts of vertical axis tidal current turbine in restricted water,” Ocean Engineering, vol. 210, p. 107320, 2020, doi: 10.1016/j.oceaneng.2020.107320.
M. Maduka and C. W. Li, “Numerical study of ducted turbines in bi-directional tidal flows,” Engineering Applications of Computational Fluid Mechanics, vol. 15, no. 1, pp. 194–209, 2021, doi: 10.1080/19942060.2021.1872706.
M. M. Nunes, A. C. P. Brasil Junior, and T. F. Oliveira, “Systematic review of diffuser-augmented horizontal-axis turbines,” Renewable and Sustainable Energy Reviews, vol. 133, p. 110075, 2020, doi: 10.1016/j.rser.2020.110075.
A. Febrianto and A. Santoso, “Analisa Perbandingan Torsi dan RPM Turbin Tipe Darrieus Terhadap Efisiensi Turbin,” Jurnal Teknik ITS, vol. 5, no. 2, 2017, doi: 10.12962/j23373539.v5i2.19414.
R. B. A. Nugraha, N. Prayogo, M. Kartidjo, and S. Nugroho, “Analisis computational fluid dynamic (CFD) dalam perancangan turbin arus laut sumbu vertikal (vertical axis ocean current turbine, VAOCT),” Journal Kelautan Nasional., vol. 8, no. 3, p. 135, 2013, doi: 10.15578/jkn.v8i3.6233.
Syahdan S. Maulana, “Analisis optimasi aliran fluida dalam pipa kondensasi water from atmosphere generator berbasis computational fluid dynamic (CFD),” Thesis, Universitas Negeri Semarang, 2019.
R. Gabl, J. Burchell, M. Hill, and D.M. Ingram, “Sensitivity analysis of a Venturi shaped structure for cross-flow turbines,” Engineering Applica-tions of Computational Fluid Mechanics, vol. 16, no. 1, pp. 2243–2269, 2022.
DOI: http://dx.doi.org/10.22441/ijimeam.v6i1.27652
Refbacks
- There are currently no refbacks.
Copyright (c) 2024 Hardi Gunawan, Nanang Ruhyat
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
INDEXED IN
Publisher Address:
Universitas Mercu Buana
Program Studi S2 Teknik Mesin
Jl. Meruya Selatan No. 1, Jakarta 11650, Indonesia
Phone/Fax. (+6221) 5871335
Email [email protected]
Homepage http://teknikmesin.ft.mercubuana.ac.id/
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.